Cissell DX4 CONTROLLER Instrukcja Użytkownika Pobierz pdf (Strona 3)

Error Codes

FB08-15 Page 3 of 18

NOTE: * To clear the not 3 error code: coin or vended machines - go to program D and press ECO button

(E). OPL models - Press the ECO button (E) and SELECT button (P) simultaniously. The letter “d” will

appear on the right side, press the ECO button (E) once again. For additional information refer to

instruction manual 249/00368/10.

Table 2

Group 2

Error Code Probable Cause Possible Corrective Actions

E7 (safety level) Water did not drain sufficiently.

• Check the drain pump

• Check water level switch

Eb (tilt switch) Tilt switch is blocked.

• Check for defective tilt switch

• Verify wiring at tilt switch is

not disconnected

not 1 (MOT no current) No current supplied to the motor.

• Verify flatcable is connected

• Check that the cycle contact

MICRO 9 closes

• Replace 16 amp fuse

• Tighten motor plug

• Replace motor print board

not 2 (tach pulse) Motor print board is not receiving

tach pulse from MICRO 9 control.

• Check wiring

• Replace tac generator

• Check contacts A, B, C or D of

MICRO 9 control

1 2 3 4 5 6 7 8 ... 17 18

Brak uwag

Cissell DX4 CONTROLLER Instrukcja Użytkownika Strona 3