Cissell DX4 CONTROLLER Instrukcja Użytkownika Pobierz pdf (Strona 10)

Error Codes

Page 10 of 18 FB08-15

A9 Motor thermal protector was

activated.

•

Check the following:

a. motor

b. motor connections

c. contactors

d. input voltage

e. inverter

f. motor and machine

bearings

Ab Level switch detects water in the

drum at the start of a cycle.

• Inspect inlet water valves

• Inspect drain valve

Ac Water was not drained after three

minutes

• Inspect drain valve

• Check drain outlet

Ad The machine is not running at

the correct RPM or the speed

sensor is defective. (If Ad is

blinking it will take 4-5 minutes

to unlock door)

• Check door lock circuit.

• Inspect door lock mechanism

AG The final spin was at a lower

RPM (smart spin) than

programmed.

• Check for an unbalanced load

AH Maximum number of tilts was

exceeded, skipping the final spin

• Check load size and type

• Check for an unbalanced load

AE Cylinder cannot find the correct

position (Hygienic machines

only)

• Press “NO” to position tub at

load or unload side, press “1”

to open load door and press “2”

to open unload door

F1 There is an invalid control

configuration, wrong

configuration file or corrupted

PS40 firmware.

•

Load a new configuration file

• Replace PS40 E Prom

F5 The door lock switch was

released during the wash cycle.

• Check door lock circuit

• Inspect door lock mechanism

F6 The door lock switch was

released during the wash cycle.

• Check door lock circuit

• Inspect door lock mechanism

FA Out of balance switch was

activated at start of cycle.

•

Check load size and type

• Check for an unbalanced load

Error Code Probable Cause Possible Corrective Actions

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Komentarze do niniejszej Instrukcji

Brak uwag